eBike Manual

How to shift gears

Only shift gears when the bike is moving and the pedals are turning but without much force on the pedal.

Tire pressure

Kyle (owner of Halls) recommended 50 psi.

Connecting the Battery

The battery snaps in place. Put the lower section of the battery in first and then the top snaps in place (make sure you hear the snap).

Disconnecting the Battery

You must use the key (in trunk) to disconnect the battery.

Storing the Battery

You should store the battery in the basement by the other batteries when it's below freezing.

Charging the Battery

The charger is stored in the basement by the other chargers. Once you plug-in the charger the 5 LED lights on the battery indicate how much charge it has. Each LED lit indicates a charge of 20%. When the battery is fully charged the LED lights switch off.

Operating the monitor

  • Press the button on the top of the monitor to start/stop the monitor.
  • To change the level of assist, press the plus/minus buttons on the left.
  • To reset your trip distance: Press and hold the minus and then press and hold the plus.
  • To change mode, hold down the minus button and release it when you see it change modes. It will start this rotation on your current mode.
    • Hold the minus it switches to Assist Level (displays level always).
    • Hold the minus again it switches to Odometer (how many miles altogether that you've ridden this bike).
    • Hold the minus again it switches to range (tells how many miles you have left when you're in each Assist Level).
    • Hold the minus it switches back to Assist Level (displays level always).
  • Less used options
    • To walk bike in with assist: any time you’re in one of the assist modes you can press the walk button on the bottom of the display. The display will have WALK+ on it. You can now press and hold the + sign and the bike will move about 2-3 miles/hour (good if you’re walking it uphill or have a flat tire).
    • To switch between miles/hour and Kilometers/hour press and hold the minus button and then tap the on/off button.
    • To turn on lights: if you have lights attached to the battery (we don't), you can turn them on/off by pressing and holding the plus. You will see a little light icon in the lower left-hand part of the display.